|
Lenovo ThinkPad L512
Mark: Average Kreso, http://www.os2world.com/component/option,com_smf/Itemid,63/topic,2545.msg17929/topicseen,1/#new
Msg 1:
Sorry to resurrect old post but since it is related to ecs installation and AHCI than it may be of interest.
Hardware: LENOVO TP L512, i5, 500GB sata HD, sata CD/DVD. For beginning this should be enough.
Problem: Booting from internal CD in AHCI mode - fail. Must be in COMPATIBILITY mode (BIOS). After first phase (first reboot) TP crashed. Reseting mode to AHCI (BIOS) system start to boot from HD but than fail with known msg:
OS/2 cannot operate your HD or ... That happens when DANI driver should be loaded, as meter of fact it start to load because there is first line of Dani driver ( /V in config,sys) Version of Danis506 is 1.8.7.
Msg 2:
So Guys there is a progress. EcS v2 is installed. Here is HOW:
- 1. BIOS - COMPATIBILITY
- 2. My own values on preboot screen
- 3. At the end of phase1 (reboot delay 20s) - eject CD
- 4. Boot Manager - EcS (booting from HD) - inserting CD 1
- 5. My surprise boot continue
- 6. Choose options
- 7. phase 2 finished (repeat as phase 1)
- 8. reboot
- 9. finish installation
- 10. reboot ALL OK I am happy, very happy Cheesy Cheesy Cheesy
Tried with AHCI - NO GO. Same as before - Dani and OS/2 cannot operate HD...
There is difference between R60 and L512 in AHCI implementation.
One more interesting think: with acpi enabled with SMP system shows 4 processors.
Pete: You are right. During last installation I change it to HPFS. Volume is compatible not LVM.
Next step is network. That I did not configure yet. I will do that at home.
Information is sent by: eComStation.RU Scout -- 2011-01-02 04:18:42
****************************************
[GoogleAdv]
|
Test the program:
|
eSchemes - change the colors and buttons on the desktop.
|
| 
